Staircase Christmas Card

A happy good morning to you! The card I'm sharing with you today may look challenging, but actually the only thing challenging about it is all the die cutting.  I cut out enough pieces for 10 cards for one of my card classes.  I have to admit that that was a lot of die cutting and I was very happy to get done.  But once done, the assembly goes easily and quickly, especially if you follow my step-by-step directions.  I think the directions are easy to follow, but if you have any questions please don't hesitate to contact me.

Finished card size 4 ½” x 6 ¼”

1.         Top fold a 4 ½” x 12 ½ “ red card base.

2.         For inside of card, cut a 4” x 5 ½” piece of white card stock and attach. 

3.         From white CS die cut the largest die from Spellbinders Card Creator Heirloom Legacy 

            (S6-010).  Attach it to the card front.

4.         From red CS die cut the small center die from the same set.  Trim off the piece along one end

            to make it straight.  This will be the bottom when attached to the wall.  Lay aside for now.

5.         From black CS cut a 4 1/8” x 4 15/16” piece.  Attach it to the front of the card over the white

            die piece.

6.         Die cut the Memory Box Classic Staircase (98665) from a piece of white CS which 

            measures 3” x 4 ¾”.  Attach to card front on the left-hand side over the black.

7.         From green CS die cut the Impression Obsession Cut Out Christmas Tree die 

            (DIE111-U).  Trace just the Christmas Tree part on red CS.  Trim the red tree inside the 

            tracing line and attach to back of green tree.  Also, die cut just the flourish part of the tree, 

            trim off the bit of the tree trunk, and glue inside the card at the bottom of the white mat.

8.         To decorate the banister, die cut at least 5 sprigs from green CS using Memory Box Small 

            Garden Sprig (931) and glue banister.

9.         I also die cut the Memory Box Mini Holly Leaves (98658) two times to use as filler on the

            banister.

10.       Punch 5 to 7 small stars from red CS and add to sprigs on the banister.

11.       Punch one larger star for the top of the Christmas Tree and glue in place.  Add Wink of 

            Stella to the Christmas tree star (GL.Clear 999).

12.       For the wall hanging, stamp a very small sentiment on white CS, punch it out with a 1” 

            scalloped oval punch, glue it to the red die cut element, attach a tiny green brad to the top, and

            then glue it to the wall. 

I hope the card inspires you.  Thanks for stopping by.

Blessings,

Annie